Daily Quest · 2026-08-05
Finish the wiring · difficulty 3 of 3
The docking-clamp status light is a dead unit, but its guts were fine, so you pulled the good RGB LED and the board out and laid them on the bench. Now there's a tidy little pile of working parts and not a single wire between them. The code's already loaded and correct — all that's left is to connect it up so the clamp reads a steady yellow.
Solve it in the free browser circuit simulator: no kit and no install needed. A new challenge every day at craftingtable.com/daily-quest; past days are in the archive.